1200 W Boost MPPT Strain-Relief & Button-Lock Shell — 6 mm² in / 4 mm² out (ID, 3D-Printable CAD)

ScootSolar

Make this part

Description

A 2-piece 3D-printable strain-relief and button-lock armor for the Indonesian MYAMI 1200 W boost MPPT solar charge controller (170 × 95 × 60 mm red extrusion). The split plane is cut through both battery leads, so the two halves clamp the 4 mm² BAT+ / BAT− pair in opposing half-round ribbed bores outboard of the green 2-position terminal block — a trip, a bag or a scooter tug pulls on the printed shell instead of on the stripped copper inside a live 88.2 V screw terminal. The bay is a skeletal frame with three full-width exhaust ducts, so all 26 of the controller's own grating slots and its clear blade fuse stay open; the PV end is an open goalpost around the unit's own IP68 gland and Ø42 mm fan. On the top face the LCD is left completely uncovered and a 20 mm bridge vaults over the 48 V / 60 V / 72 V selector and the blue Set button (with a Ø2 mm paperclip pinhole), so the charge-voltage target cannot be knocked. Both halves slide over the unit's 8 endplate corner screws, and four flat Ø5.5 mm ears bolt the assembly down.

Specifications

Rolemppt-armor-id-1200w
For Controller Idmppt-boost-1200w-id
Wire mm²6
Wire In mm²6
Wire Out mm²4
Cable Od Mm6.1
Cable In Od Mm7.2
Cable Out Od Mm6.1
Build3d-printable-cad
Screw Count4
Screw SpecM3 x 20 mm
Mounting Hole Mm5.5

What you still need to source

The download is the plastic only. These are the rest, and the contact is the one that decides whether it works.

Print settings

OrientationSplit face DOWN, both halves
SupportsNone — the channels print open
Layer height0.2 mm (0.12 mm on the split face if the channels feel rough)
Walls3–4 — the shroud plates are only 2 mm thick, so the walls are the part
Infill15–20 %, gyroid or grid
MaterialASA outdoors, PETG indoors. Never PLA

Assembly

  1. 1. Set the charge voltage and verify it with a multimeter first

    Before you close the shell, set the 48 V / 60 V / 72 V selector to your pack and check the output with a multimeter against your OEM charger's nameplate rating. Once the shell is on, the selector and the Set button are reachable only through a Ø2 mm paperclip pinhole — that is the point of the bridge, and it is also why the voltage has to be right first.

  2. 2. Terminate the battery pair and seat the unit in the bottom shell

    Terminate BAT+ and BAT− into the green 2-position block (the two screws sit inside the bay, so a screwdriver reaches them), then lower the cabled controller into the bottom cradle. Its two leads settle into the half-round ribbed channels, which only become full Ø6.3 mm bores once the top shell closes on them. The PV pair leaves through the unit's own IP68 gland and is left alone.

  3. 3. Slide the top shell down and drive the four M3 screws

    Lower the top shell straight down — the vertical slots at both ends let it slide over the unit's 8 endplate corner screws without unscrewing anything — then drive the four M3 × 20 mm corner screws in. Tightening them is what pinches the ribbed bores onto the battery jackets.

Parts you’ll need

Please purchase the remaining off-the-shelf parts here to complete the adapter.