Make this part
Description
A 2-piece 3D-printable right-end strain-relief cap and tamper-proof button/screw-hole lock shield designed around the real Thai MPT-7210A extruded green aluminum boost MPPT controller. Clamps the top Solar PV pair and bottom Battery pair in split-plane half-round ribbed channels where they exit the right end of the controller, shields the 4 vertical screwdriver holes and the SET / ▲ / ▼ / OK button column against accidental bumps, and hooks into the extruded C-rails and rear corners while leaving the LCD, heatsink fins, and left-end 40 mm fan 100% open.
Specifications
| Role | mppt-armor-7210a |
|---|---|
| For Controller Id | mppt-7210a |
| Wire mm² | 4 |
| Wire In mm² | 4 |
| Wire Out mm² | 4 |
| Cable Od Mm | 6.1 |
| Cable In Od Mm | 6.1 |
| Cable Out Od Mm | 6.1 |
| Build | 3d-printable-cad |
| For Controller Ids | mppt-7210a – mppt-jnge-boost-id |
What you still need to source
The download is the plastic only. These are the rest, and the contact is the one that decides whether it works.
Print settings
| Orientation | Split face DOWN, both halves |
|---|---|
| Supports | None — the channels print open |
| Layer height | 0.2 mm (0.12 mm on the split face if the channels feel rough) |
| Walls | 3–4 — the shroud plates are only 2 mm thick, so the walls are the part |
| Infill | 15–20 %, gyroid or grid |
| Material | ASA outdoors, PETG indoors. Never PLA |
Assembly
1. Wire the MPT-7210A and verify your pack's CV target first
Before closing the armor, connect your solar panel, set the MPT-7210A output voltage to your pack's verified CV target (from the OEM charger label, checked with a multimeter), and tighten the 4 terminal screws through the top access holes.
2. Seat the controller and cables in the bottom half
Set the MPT-7210A into the bottom cradle between the front shoulder and rear corner hooks, and lay the 2 Solar PV leads and 2 Battery leads into the 4 half-round ribbed channels.
3. Close the top button-lock cover and tighten the 4 screws
Lower the top shell so its 4 upper half-round channels mate directly over the 4 cables and its lock tongue covers the SET / ▲ / ▼ / OK buttons and the 4 screwdriver holes, leaving the LCD and left-end cooling fan completely open.
Parts you’ll need
Please purchase the remaining off-the-shelf parts here to complete the adapter.