MPT-7210A Outdoor Safety Shell — 6 mm² in / 6 mm² out (3D-Printable CAD)

ScootSolar

Make this part

Description

A 2-piece 3D-printable right-end strain-relief cap and tamper-proof button/screw-hole lock shield designed around the real Thai MPT-7210A extruded green aluminum boost MPPT controller. Clamps the top Solar PV pair and bottom Battery pair in split-plane half-round ribbed channels where they exit the right end of the controller, shields the 4 vertical screwdriver holes and the SET / ▲ / ▼ / OK button column against accidental bumps, and hooks into the extruded C-rails and rear corners while leaving the LCD, heatsink fins, and left-end 40 mm fan 100% open.

Specifications

Rolemppt-armor-7210a
For Controller Idmppt-7210a
Wire mm²6
Wire In mm²6
Wire Out mm²6
Cable Od Mm7.2
Cable In Od Mm7.2
Cable Out Od Mm7.2
Build3d-printable-cad
For Controller Idsmppt-7210a – mppt-jnge-boost-id

What you still need to source

The download is the plastic only. These are the rest, and the contact is the one that decides whether it works.

Print settings

OrientationSplit face DOWN, both halves
SupportsNone — the channels print open
Layer height0.2 mm (0.12 mm on the split face if the channels feel rough)
Walls3–4 — the shroud plates are only 2 mm thick, so the walls are the part
Infill15–20 %, gyroid or grid
MaterialASA outdoors, PETG indoors. Never PLA

Assembly

  1. 1. Wire the MPT-7210A and verify your pack's CV target first

    Before closing the armor, connect your solar panel, set the MPT-7210A output voltage to your pack's verified CV target (from the OEM charger label, checked with a multimeter), and tighten the 4 terminal screws through the top access holes.

  2. 2. Seat the controller and cables in the bottom half

    Set the MPT-7210A into the bottom cradle between the front shoulder and rear corner hooks, and lay the 2 Solar PV leads and 2 Battery leads into the 4 half-round ribbed channels.

  3. 3. Close the top button-lock cover and tighten the 4 screws

    Lower the top shell so its 4 upper half-round channels mate directly over the 4 cables and its lock tongue covers the SET / ▲ / ▼ / OK buttons and the 4 screwdriver holes, leaving the LCD and left-end cooling fan completely open.

Parts you’ll need

Please purchase the remaining off-the-shelf parts here to complete the adapter.