Make this part
Free
Description
A 1-piece 3D-printable 45° interlocking PV cable bend-guide segment (v2) that clips onto a pair of 6 mm² solar cables (Ø7.2 mm jacket) and holds them on a fixed R135 mm inner-wire radius — so 4 segments make a 27 cm (270 mm) 180° U-turn and 8 segments form a 27 cm circle, matching the 27 cm coil the 6 mm² cable ships in. Version 2 eliminates bulky external side wings in favour of flush outer walls, a single central spine snap-together nub between the two cable channels, and overlapping male/female coaxial snap affixing rings at both ends (0° bottom half + 45° top half) that snap together and get staked into the ground with a single stake or ground-anchor screw through both halves. Also cross-compatible with the 120 mm straight wire guide segment.
Specifications
| Role | pv-bend-guide |
|---|---|
| Build | 3d-printable-cad |
| Wire mm² | 6 |
| Cable Od Mm | 7.2 |
| Bend Radius Mm | 135 |
| Circle Diameter Cm | 27 |
| Arc Deg | 45 |
| Lanes | 2 |
| Segments Per180 | 4 |
| Segments Per360 | 8 |
| Joint | central-spine-snap-and-coaxial-end-ring |
What you still need to source
The download is the plastic only. These are the rest, and the contact is the one that decides whether it works.
Print settings
| Material | ASA or PETG — never PLA |
|---|---|
| Orientation | Flat on the bed (channel opening facing +Z) |
| Supports | None |
| Layer height | 0.2 mm |
| Walls / perimeters | 3 (≥ 1.2 mm) |
| Infill | 20–25 % gyroid or grid |
Assembly
1. Snap two segments together at the central nub and coaxial end ring
Push the central spine male nub of one segment into the central female socket of the next while snapping the 45° top-half end ring over the 0° bottom-half ring's coaxial snap collar.
2. Snap your red and black PV cables in from above
Press each cable down through the 0.82 × OD throat into its half-round groove; the two stiff cables act as continuous splines across the joint while the retention lips lock them in place.
3. Stake the mated end rings together or combine with straight segments
Drive a tent stake or ground-anchor screw hook through the shared Ø6.4 mm coaxial end ring to pin both halves to the ground, and snap 120 mm straight segments onto either end for straight runs or elongated U-turns.
Parts you’ll need
Please purchase the remaining off-the-shelf parts here to complete the adapter.