PV Cable Wire Guide — 120 mm Interlocking Straight Segment, 6 mm² (3D-Printable CAD)

ScootSolar

Make this part

Free

Description

A 1-piece 3D-printable 120 mm (12 cm) interlocking straight PV cable wire-guide segment for a pair of 6 mm² solar cables (Ø7.2 mm jacket). Shares the exact same twin U-channel cross-section, central spine snap-together nub, and overlapping male/female coaxial snap affixing rings at both ends (y = 0 bottom half + y = 120 mm top half) as the 45° bend guide (pv-bend-guide-45-6mm v2), so straight and 45° curved segments snap directly into each other in any combination.

Specifications

Rolepv-wire-guide-straight
Build3d-printable-cad
Wire mm²6
Cable Od Mm7.2
Length Mm120
Lanes2
Jointcentral-spine-snap-and-coaxial-end-ring

What you still need to source

The download is the plastic only. These are the rest, and the contact is the one that decides whether it works.

Print settings

MaterialASA or PETG — never PLA
OrientationFlat on the bed (channel opening facing +Z)
SupportsNone
Layer height0.2 mm
Walls / perimeters3 (≥ 1.2 mm)
Infill20–25 % gyroid or grid

Assembly

  1. 1. Snap straight and 45° curved segments together in any order

    Push the central spine male nub of one segment into the central female socket of the next (straight or 45° curved) while snapping the top-half end ring over the bottom-half ring's coaxial snap collar.

  2. 2. Snap your red and black PV cables in from above

    Press each cable down through the 0.82 × OD throat into its half-round groove; the twin retention lips on the outer wall and central ridge close behind the jacket.

  3. 3. Stake the mated end rings into the ground together

    Drive a tent stake or ground-anchor screw beside the joint so its hook drops into the shared Ø6.4 mm coaxial ring bore, locking both segments down.

Parts you’ll need

Please purchase the remaining off-the-shelf parts here to complete the adapter.